Ge druck trx-ii manual

Select required language and press EXE. Select Temp. Type in the access code and press EXE to confirm. You are now in a mode where you can change the code. Select system and press EXE. Page 22 Dec. Select DEC. Press CE to leave the set-up menu. The upper window in the working screen indicates the measured millivolts reading. The range is mV split into two auto ranges of 0 to mV and to mV. The upper window in the working screen indicates the measured ohms reading.

The range is Ohms split into two auto ranges of 0 to Ohms and to Ohms. The excitation current is 0. Select FREQ. Enter a trigger level between 10 mV and 5. Closing the test loop will activate the built-in buzzer to prove that the wiring loop has a resistance of Ohms or less. Press EXE to enter. Note that in this mode temperature changes at the instrument terminals can easily create calibration errors. Page 30 Select the connected sensor from the available sensors with the key, and press EXE.

Press CE to leave menu. The next menu gives you all the details of the selected sensor. This information should be checked with the sensor information on the connector. Page 31 Press to unlock the switch reading. The switch reading will track the source reading again. Make sure that contacts are potential free. This facility is available on both measurement and source functions.

It puts you right in the source mode. Measure Pressure:. Output mA:. Output mV:. Output V:. Output Frequency:. Output Pulses:. Output V:. Output Frequency:. Output Pulses:. Pressure Connection:. Electrical Scaling:. Data Logging:. PC Interface:. Applications Engineer 15 years at Instrumart. Mark D. Applications Engineer 10 years at Instrumart.

Brynn O. Applications Engineer. Mike K. Angelo S.