How to program explorer keyless

Step by Step How to Program Instructions:. To program the key portion of the key you must first get key cut by a locksmith and already have two working keys. If you only have one working key then you will have to have a locksmith program a second key with special equipment. Insert an existing working key into the ignition cylinder. Remove second working key and insert the new key before ten seconds have elapsed and turn it to ON RUN. Leave it on for one second and turn back to OFF.

We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Time needed: 3 minutes. If the key was successfully programmed, the theft indicator light will illuminate for 3 seconds and then go out to indicate successful programming of the key.

Wait 20 seconds and repeat the process from Step 1. If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same.

Note: If your vehicle cannot enter programming mode, then you cannot program any remote. This indicates either no keyless entry installed on the vehicle or a defective keyless entry receiver module. Ignition should stay in ON position for at least 3 seconds. Ignition must be on for at least 3 seconds but no more than ten seconds. Remove key. Insert the New unprogrammed key before10 seconds have elapsed and turn it to ON. Remove the key and test it. If programming was not successful, wait 10 seconds and repeat the above steps.

They must be programmed by an automotive locksmith or dealership. We know how good it feels to save money and do something yourself; and we aim to make it as painless as possible for you!

Time needed: 3 minutes. Wait 20 seconds and repeat the process from Step 1. If these programming instructions helped save you time and money, please consider sharing our website with friends and family so they can do the same. Note: If your vehicle cannot enter programming mode, then you cannot program any remote.

This indicates either no keyless entry installed on the vehicle or a defective keyless entry receiver module.